Casio V-T500-GE User Manual page 115

■
Status of Charge LED on V-T500:
Orange: Charging (battery level at 6% or more)
Red: Battery level down to 0-5%
(until a level of 5%, tablet will not start up)
Battery pack error
Blinking red: Standby due to being outside the temperature range for charging
(charging begins when the temperature is within the charging temperature range)
Green: Charging complete
* If, after 30 minutes or more at normal temperature, you plug the AC adaptor in again
and the charge LED is still red or off, there is a fault. Immediately stop using the
product and contact the dealer or distributor where you purchased the product, or an
authorized CASIO service provider.
* If the remaining battery change is 5% or less when the AC adaptor is connected
correctly, the charge LED turns off for approximately 0.5 seconds and then lights red.
Important !
•
Never short out the communication/power supply terminals of the Ethernet
Cradle. This can damage the Ethernet Cradle.
•
Allowing the communication/power supply terminals become wet can cause an
electric shock or fi re. In addition, if the terminals become soiled, contact may
be impaired resulting in poor charging. For reasons of safety and maintaining
charging battery pack(s) in optimum condition, clean the communication/power
supply terminals by wiping with a dry cloth or cotton swab after disconnecting
the AC adaptor.
•
Do not subject the tablet and Ethernet Cradle to vibration or impact during
communication. This can cause communication to be interrupted.
•
When placing the V-T500 into the cradle, make sure that it is seated properly
and that the power indicator LED at the front of the Ethernet Cradle is lit in
green. Charging and communication will not proceed properly if the tablet is not
seated properly.
•
The USB Mini-B port on the tablet cannot be used while the tablet is fi tted into
the Ethernet Cradle.
•
Always cap ports that are not being used. Using the Ethernet Cradle while the
ports are uncapped can cause damage.
E-113