Table of Contents
Advertisement
Reset
Use one end of a paperclip to press and hold into the reset hole for 5 seconds to
reset Wi-Fi, detector settings, and to re-start Bluetooth pairing. The LED will blink
blue.
Press and hold the paperclip into the reset hole for 15 seconds to restore factory
defaults. The LED will blink blue.
Status LED
The detector has an LED that gives device status.
LED
During installation
Blinking blue
Solid blue
Blinking green
Solid green
Solid red
During operation
Blinking red
For help, go to getconnected.honeywell.com
Detector state
Powering up and connecting to Bluetooth.
Paired with Bluetooth.
Connecting to Wi-Fi network.
Has power, Wi-Fi connection, and is operating
normally.
Note: LED turns off after 5 minutes to preserve
battery life.
Failed to connect to Wi-Fi.
Detected a leak.
20
Advertisement
Table of Contents
