D-Link DCS-900 Quick Installation Manual page 5

Running the Setup Wizard
To run the Setup Wizard, click on
Start->Programs->DCS-900 Series
SetupWizard.
Your camera's IP Address will be
displayed here if it is valid.
Click Wizard to begin
You must change the Admin ID and
Password immediately to protect
your camera against unauthorized
access. By default, the Admin ID and
Password are blank. To change the
Admin ID and Password, select both
Change boxes and enter a New ID
and New Password.
Click Next
Enter an IP Address and Subnet
Mask for your camera. Enter your
Gateway and DNS settings. These
settings must correspond with your
network settings for you to access
the camera. If you are unsure of what
these settings should be, check with
your network administrator.
Click Next
5
(continued)