Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEG L 71479 FL
Summary of Contents for AEG L 71479 FL
- Page 1 EN User manual L 71479 FL L 71470 FL L 71670 FL...
-
Page 2: Table Of Contents
12. INSTALLATION ............26 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler –... -
Page 3: Safety Information
ENGLISH 1. SAFETY INFORMATION Before the installation and use of the appliance, careful- ly read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use cau- ses injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability. -
Page 4: Safety Instructions
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali- fied persons in order to avoid a hazard. • The operating water pressure (minimum and maxi- mum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) •... -
Page 5: Technical Information
ENGLISH Water connection • Do not put a container to collect pos- sible water leakage under the appli- • Make sure not to cause damage to the ance. Contact the Service to ensure water hoses. which accessories can be used. •... -
Page 6: Product Description
Maximum load Cotton 7 kg Spin speed Maximum 1400 rpm (L 71479 FL) 1400 rpm (L 71470 FL) 1600 rpm (L 71670 FL) 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 4. PRODUCT DESCRIPTION... -
Page 7: Control Panel
ENGLISH Spanner To remove the transit bolts. Plastic caps To close the holes on the rear side of the cabinet after the removal of the transit bolts. Anti-flood inlet hose To prevent possible leakage Plastic hose guide To connect the drain hose on the edge of a sink. - Page 8 5.3 Display The display shows: • The maximum temperature of the programme. • The default spin speed of the programme. • 'No Spin' and 'Rinse Hold' symbols. • The display symbols. Symbols Description Washing phase Rinse phases Spin phase...
- Page 9 ENGLISH • The programme time When the programme starts, the time decreases with steps of 1 mi- nute. • The delay start When you press the delay start button, the display shows the delay start time. • Alarm codes If the appliance has a malfunction, the display shows alarm codes. Re- fer to 'Troubleshooting' chapter.
-
Page 10: Programmes
10 www.aeg.com • To activate the function, press button Spin phase is off. and button at the same time until the display shows the symbol 'Rinse Hold' function is • To deactivate the function, press but- and button at the same time until the symbol goes off. - Page 11 ENGLISH Programme Type of load Cycle Functions Temperature max. weight of load description Extra Leise White and coloured Wash FLECKEN 95° - Cold cotton with normal Rinses EXTRA SPÜLEN soil. Stop with water in ZEIT SPAREN max. 7 kg the drum Pflegeleicht Synthetic or mixed Wash...
- Page 12 12 www.aeg.com Programme Type of load Cycle Functions Temperature max. weight of load description Gardinen Set this programme Prewash SPIN REDUC- 40° - Cold to wash curtains. It Wash TION adds automatically Rinses RINSE HOLD the prewash phase to Short spin EXTRA SPÜLEN...
- Page 13 ENGLISH 6) Set this programme to decrease the time and the consumption of energy and water. 7) According to regulation 1061/2010, these programmes are respectively the “standard 60 °C cotton programme” and the “standard 40 °C cotton programme”. They are the most efficient programmes in terms of combined energy and water consumptions for washing normally soiled cotton laundry.
-
Page 14: Before First Use
14 www.aeg.com Programmes Load Energy con- Water con- Approxi- Remaining (Kg) sumption sumption (li- mate pro- moisture (kWh) tre) gramme duration (minutes) The information given in the chart above are in compliance with the EU Com- mission regulation 2015/2010 implementing directive 2009/125/EC. - Page 15 ENGLISH The detergent compartment for the prewash phase, the soak programme and for the stain function. Add the detergent for prewash, soak and stain remover before the start of the programme. The detergent compartment for the washing phase. If you use a liquid detergent, put it immediately before you start the programme.
- Page 16 16 www.aeg.com To use powder detergent, turn the flap up. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid deter- gent than the limit showed in the flap.
- Page 17 ENGLISH If the temperature and level of Press button again to activate the water in the drum are too the appliance. Now, you can set a high, the door lock symbol stays new washing programme. on and you cannot open the The appliance does not drain the door.
-
Page 18: Hints And Tips
18 www.aeg.com Deactivate the appliance. Press the Start/Pause button The appliance drain the water and The appliance drain and spin au- spin. tomatically after approximately When the programme is completed 18 hours. and the door lock symbol goes off, you can open the door 9. -
Page 19: Care And Cleaning
ENGLISH • mmol/l (millimol for each litre - inter- • Clarke degrees. national unit for the hardness of wa- ter). Water hardness table Water hardness Level Type °dH °T.H. mmol/l Clarke soft 0-15 0-1.5 medium 8-14 16-25 1.6-2.5 10-16 hard 15-21 26-37 2.6-3.7... - Page 20 20 www.aeg.com 10.5 Drum • Clean the drum with special product for stainless steel. Regularly examine the drum to prevent • Start a short programme for cotton at limescale and rust particles. the maximum temperature with a Only use special products to remove rust small quantity of detergent.
- Page 21 ENGLISH WARNING! Disconnect the mains plug from the mains socket. Do not remove the filter while the appliance oper- ates. Do not clean the drain pump if the water in the ap- pliance is hot. The water must be cold before you clean the drain pump.
- Page 22 22 www.aeg.com Make sure that the impeller of the pump can turn. If this does not oc- cur, contact the service centre. Clean the filter under the water tap and put it back in the pump into the special guides.
-
Page 23: Troubleshooting
ENGLISH Remove the inlet hose behind the appliance. Clean the filter in the valve with a stiff brush or a towel. Install again the inlet hose. Make sure that the couplings are tight to prevent leakages. Open the water tap. 45°... - Page 24 24 www.aeg.com • • - The appliance does not drain - The anti-flood device is on. the water. WARNING! • - The appliance door is open or Deactivate the appliance before not closed correctly. you do the checks. Problem Possible cause...
- Page 25 ENGLISH Problem Possible cause Possible solution The filter of the drain Clean the filter of the drain pump is blocked. pump. Refer to 'Care and clean- ing'. Balance problems with Adjust manually the items in the the laundry load. tub and start the spin phase again.
-
Page 26: Installation
26 www.aeg.com Problem Possible cause Possible solution You did not remove the Use special products to remove stubborn stains before the stubborn stains. you wash the laundry. Incorrect temperature Make sure that you set the cor- was set. rect temperature. - Page 27 ENGLISH Remove the internal film. Open the door and remove all the items from the drum. Put one of the polystyrene packag- ing elements on the floor behind the appliance. Carefully put down the appliance with the rear side on it.
- Page 28 28 www.aeg.com Remove the power supply cable and the drain hose from the hose hold- ers. Remove the three bolts. Use the key supplied with the appliance. Pull out the plastic spacers. Put the plastic caps in the holes. You can find these caps in the user manual bag.
- Page 29 ENGLISH 12.3 Positioning and levelling • Install the appliance on a flat hard floor. • Make sure that carpets do not stop the air circulation below the appliance. • Make sure that the appliance does not touch the wall or other units •...
- Page 30 30 www.aeg.com • Connect the water inlet hose to the cold water tap with 3/4 thread. CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Con- tact the service centre for the re- placement of the inlet hose.
- Page 31 ENGLISH • On the edge of a sink. • Make sure that the plastic guide can- not move when the appliance drains. Attach the guide to the water tap or the wall. • To a stand pipe with vent-hole. Refer to the illustration. Directly into a drain pipe at a height of not less than 60 cm and not more than 100 cm.
- Page 32 32 www.aeg.com 13. ENVIRONMENT CONCERNS Recycle the materials with the appliances. Do not dispose symbol . Put the packaging in appliances marked with the symbol applicable containers to recycle it. with the household waste. Return the Help protect the environment and...
- Page 33 ENGLISH...
- Page 34 34 www.aeg.com...
- Page 35 ENGLISH...
- Page 36 www.aeg.com/shop...