Table of Contents
Advertisement
Remote control
Battery installation
Use 2 "AAA" size battery (UM/SUM-4, R3, HP-16 or
similar). Battery is not included.
1
Open the battery cover.
2
Insert the batteries according to the terminal indicated in
the battery compartment. When inserting or removing the
batteries, push them toward the (–) battery terminals.
3
Close the cover.
Caution:
Replace all old batteries with new ones at the same
time.
Do not mix old and new batteries.
Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
Installing the batteries incorrectly may cause the unit
to malfunction.
Batteries (battery pack or batteries installed) shall not
or the like.
General control
To turn the power on
Press the ON/STANDBY button to turn the power on or off.
Display brightness control
Press the DIMMER button (remote control).
(Display is dim).
Dimmer 1
(Display gets dimmer).
Dimmer 2
(Display is bright).
Dimmer off
Volume auto fade-in
If you turn off and on the main unit with the volume set to
27 or higher, the volume starts at 16 and fades in to the
last set level.
Volume control
Turn the volume knob toward VOLUME +/– (main unit) or
press VOL +/– (remote control) to increase or decrease
the volume.
Muting
To mute the volume, press the
Press again to restore the volume.
Direct key power on function
When you press any of the following buttons, the unit turns
on.
CD
/ , USB
/ , BLUETOOTH
TUNER (BAND), OPEN/CLOSE (remote control) :
Selected function is activated.
/ (main unit): The unit turns on and playback of the last
function will start (CD, TUNER, USB, AUDIO IN,
LINE IN, OPTICAL IN, PC IN, BLUETOOTH)
button (remote control).
/ ,
INPUT
Notes concerning use:
Replace the batteries if the operating distance is reduced
or if the operation becomes erratic. Purchase 2 "AAA"
size batteries (UM/SUM-4, R3, HP-16 or similar).
Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may in-
terfere with operation. Change the lighting or the direc-
tion of the unit.
Keep the remote control away from moisture, heat,
shock, and vibrations.
Test of the remote control
The remote control can be used within the range shown below:
Remote sensor
8" - 20'
(0.2 m - 6 m)
Auto power off function
The main unit will enter the standby mode after 15 minutes
of inactivity during:
Audio/Line In/Optical In/PC In: No detection of input signal.
CD: In the stop mode or no disc.
USB: In the stop mode or no media.
Bluetooth: - No connection after approximately 15 minutes.
- In the pause or stop mode and no incoming sig-
nal from device after approximately 15 minutes.
X-Bass control
bass mode. "X-BASS" indicator appears. To cancel this
mode, press the X-BASS button (remote control).
Bass or Treble control
1
Press the BASS or TREBLE button to select "Bass" or "Tre-
ble" respectively.
2
Within 5 seconds, press the VOL (+ or –) button to adjust the
bass or treble.
- 4 ........
- 5
Function
Press the FUNCTION button repeatedly to select desired
function.
CD
FM STEREO
Bluetooth
PC In
Optical In
Note:
The backup function will protect the memorized function
mode for a few hours should there be a power failure or
the AC power cord becomes disconnected.
E-7
- 4 ........
- 5
4
5
FM MONO
Audio In
Line In
4
5
AM
USB
Advertisement
Table of Contents
