Setting Up The Floorstand Model - Fujitsu PRIMERGY TX2560 M2 Operating Manual

5.2

Setting up the floorstand model

I
If you are not installing a PRIMERGY TX2560 M2 floorstand model, skip
this section and continue reading at section
model" on page
V
CAUTION!
Please note the safety instructions in chapter
page 35.
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see
Ê Set up the server.
V
CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê Wire the server. Read the information in section
server" on page 54
on page 58.
Ê Connect the system to the mains (see
mains" on page
TX2560 M2 / RX2560 M2
52.
section"Unpacking the server" on page
and section "Notes on connecting/disconnecting cables"
56).
Operating Manual
Hardware installation
"Installing/removing the rack
"Important information" on
"Connecting devices to the
section"Connecting the server to the
50).
51