Advertisement
Procedure 3A → 3B → 3C → 3D → 3E → 3F
Ref. No. 3F
Assembly of the Adjusting Screw and the Clutch Handle.
for EY7441
1. Hold the driving block with the click spring on top, and align the
narrow projection of adjusting screw with 45° right side of the clutch
case.
NOTE:
Make sure that the adjusting screw has its own correct direction
for proper assembly. Failure to do so, the clutch handle does not
rotate properly.
2. Turn the adjusting screw into the driving block about one rotation
for clockwise direction.
3. Set the clutch handle with position 1 on top.
(Align the position 1 of clutch handle with the narrow projection of
driving block.)
4. Insert the clutch handle with adjusting the tabs of adjusting screw
to the groove of inside clutch handle.
11
Advertisement
