Table of Contents
Advertisement
Message Lists
Warning messages
Message
High temp.! Lamp off in 1
min.
Frequency is out of range!
Please check Input-A
Signal Sel.
Please replace the Lamp/
Filter.
Please clean the filter.
Please clean the filter. Have
you finished? Yes No
Projector temperature is
high. Cooling Setting
should be "High" if
projector is being used at
high altitude.
Caution messages
Message
x
Not applicable!
68
Cause and Remedy
c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes.
(1 page 14)
c Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector. (1 page 77)
c Set "Input-A Signal Sel." in the Setup
"Computer" when an RGB signal is input from a computer.
(1 page 54)
c It is time to replace the lamp. Replace the lamp. (1 page 69)
c Also, replace the air filter too. Restart cleaning the ventilation
holes (intake). (1 page 69)
If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process. (1 page 69)
Note
To clear this message, press any button either on the remote control
or the control panel of the projector once.
c It is time to clean the air filter. Clean the air filter. (1 page 72)
Note
To clear this message, press any button either on the remote control
or the control panel of the projector once.
c It is time to clean the air filter. Clean the air filter. (1 page 72)
c If you cleaned the air filter, select "Yes." If you did not clean the
air filter, select "No."
c Check to ensure that the ventilation holes on the unit are not
covered. (1 page 8)
c When using the projector at high altitude, set the Cooling
Setting to "High". (1 page 53)
Note
When temperature inside the projector remains high, the Cooling
Setting is switched to "High" in 1 minute, then the fan speed
increases.
Cause and Remedy
c No signal is input in the selected input. Check connections.
(1 page 25)
c Press the appropriate button.
c The operation to be activated by the button is currently
prohibited.
menu to
Advertisement
Table of Contents
