Table of Contents
Advertisement
Connecting to an Optional TMR-PJ1 3D Sync Transmitter*
The optional TMR-PJ1 3D Sync Transmitter* is required to view projected 3D video
images.
Right side of the projector
LAN cable (not supplied)
: 3D sync signal flow
Tip
Place the optional 3D Sync Transmitter directly facing the 3D glasses. Also, in order to stabilize
operation of the 3D glasses, it is recommended that you place the 3D Sync Transmitter near your
viewing position.
CAUTION
Be sure to use straight-type LAN cable of up to 15 m labeled TYPE CM, and do not use
an extension cord.
Notes
• Turn off the projector before connecting the 3D Sync Transmitter, otherwise the 3D Sync
Transmitter is not recognized.
• The 3D SYNC connector is dedicated for the optional 3D Sync Transmitter. Do not connect
computers or other network devices, to avoid malfunction.
• Be sure to use straight-type LAN cable (not supplied) labeled Cat-7 (Category 7). If you use other
than the specified cable, the 3D Sync Transmitter may occasionally not work.
• Be sure to use cable of up to 15 m, and do not use an extension cord. Also, keep the LAN cable
away from any AC power cords as much as possible.
• Up to one TMR-PJ1 can be connected to a projector. Never connect multiple TMR-PJ1 units,
which may cause a malfunction.
* 3D Sync Transmitter is supplied with VPL-HW30AES.
28
TMR-PJ1 3D Sync Transmitter
(not supplied)*
Advertisement
Table of Contents
