Honeywell CM727 User Manual page 10

'Efficient Daily Use'
The Built-in Heating Program
The built-in heating program has 4 temperature level changes per day that can be set between
3.00am and 2.50am the following day - allowing you to maintain the evening temperature after
midnight. Each temperature level can be set between 5°C and 35°C, and adjusted in 0.5°C
increments. The factory default program for heating is as follows.
Monday to Friday
(Day 1 to 5)
Saturday & Sunday
(Day 6 & 7)
Reviewing the Heating Program
To review or edit the heating program use the PROGRAM
4 individual programming periods for that day. Use the DATE/DAY button to step through each day of
the week, so the complete 7 day heating program can be reviewed or edited.
Modifying the Heating Program
To change the heating program:
a. Press either of the PROGRAM
enter the programming mode. The time / temperature
settings for period 1 on Monday (Day 1) will be
flashing as shown. The active period is highlighted by
a flashing square around the numbers at the bottom of
the screen and the selected day is shown with the day
indicator.
b. To adjust the period start time use the
confirm the change. Holding the button down will change the time quickly.
Note: If you are pressing the
means the next period will be pushed forward.
c. Once the required time is reached press the green
Note: If the original time setting did not require adjustment press the green
to step 'd'.
d. The temperature setting for period 1 on Monday (Day 1) will now be flashing. To adjust this
press the or buttons and confirm the setting again by pressing the green
e. The next time and temperature period will now be active. Adjust this by repeating steps b - d
above until all 4 periods are set for Monday or press the AUTO button to run the program as
set, at any time.
You now have a choice of how to set the program for the next day:
10
Period
Time
Temperature
Period
Time
Temperature
or buttons to
or buttons, the 'OK?' indicator will be displayed to
or buttons and the display flashes the next period, it
PROGRAMMING THE CM727
1 2
6:30 8:00
21°C 18°C
1 2
8:00 10:00
21°C 21°C
or buttons to navigate between the
1 2 3
button to confirm.
3 4
18:00 22:30
21°C 16°C
3 4
18:00 23:00
21°C 16°C
4 5 6 7
1 2 3 4
button to move
button.