Table of Contents
Advertisement
1. Install the anti-tilt protection 325 -
330 mm down from the top surface
of the appliance and 126 - 130 mm
from the side of the appliance into
the circular hole on a bracket. Screw
it into the solid material or use
applicable reinforcement (wall).
2. You can find the hole on the left side
at the back of the appliance. Lift the
front of the appliance and put it in
the middle of the space between the
cupboards. If the space between the
bench cupboards is larger than the
width of the appliance, you must
adjust the side measurement to
centre the appliance.
If you changed the
dimensions of the cooker,
you must align the non-tip
device correctly.
CAUTION!
If the space between the
bench cupboards is larger
than the width of the
appliance, you must adjust
the side measurement to the
centre of the appliance.
15. ELECTROLUX / AEG MAJOR APPLIANCES -
WARRANTY CONDITIONS
For domestic use only.
126-130
mm
325-330
mm
14.15 Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
Connection to the mains
1. Fit the power cable with a
standardized plug suitable for the
load indicated on the data label.
2. Connect the wires as shown below.
3. Remember that the earth wire must
be longer than the phase wires
letter
L (phase)
letter
N (neutral)
symbol
(earth)
WARNING!
The power cable must not
touch the part of the
appliance shaded in the
illustration.
Not for commercial or industrial use.
ENGLISH
31
= brown wire
= blue wire
= green/yellow
wire
Advertisement
Table of Contents
