Table of Contents
Advertisement
2.8 HDD BUTTON
In the Vega Video's front panel you find the HDD button. This allows the "safe removal" of the USB memory
device possibly connected to the HDD USB port. The same operation can be performed through the
configuration pages. To deactivate the external USB memory, hold the button for about 4 seconds and wait
for the HDD LED to switch off. Now you can disconnect the USB memory from the Vega Video.
2.9 RST BUTTON
In the Vega Video's front panel you find the RST button. This button is associated with the following
functions:
- Upload of the factory settings = with the main power on, hold the RST button until the GSM, HDD and
WLAN Leds turn on.
- Switching off = after turning off the power supply, the Vega Video stays on thanks to the backup battery. To
switch it off definitely, hold the RST for a few seconds and wait for it to switch off.
2.10 FACTORY SETTINGS
When first started, the Vega Video shows the factory parameters indicated in the following table. To access
the configuration, connect the Network Interface Card of your PC to one of the Vega Video's 4 LAN ports,
using the Ethernet cable in the package. Follow the instructions described in the CONFIGURATION chapter.
24
Vega Video
User Id:
Password:
LAN Address:
Subnet Mask:
Gateway:
WLAN Address:
WEP:
SSID:
Channel:
Backup battery: 20 minutes' activity.
(In case of main power supply lack, the Vega Video
will be active for 20 minutes before turning off).
admin
digicom
192.168.1.1
255.255.255.0
0.0.0.0
192.168.2.1
Enable
Digicom
1
Advertisement
Table of Contents
