NEC UNIVERGE SV8100 System Hardware Manual page 494

Issue No. 1.5
10 - 42
DO NOT install the NEC BackOffice Software
until instructed! It is critical that you follow the
steps in the installation procedure in the order
listed below. Failure to do so will result in an
unsuccessful installation.
The installer will need to prepare the wiring to tap off the
digital pair with a T-Connect type setup.
It may be desirable to fasten the devices to a PC or rack.
Since the devices are light in weight, this can be done quite
easily with Velcro tape.
11.5.6.2 Set Up PC
1. Set up the PC with the appropriate number of USB
Controller Cards and/or USB hubs for the number of
4-Port Digital Call Logging Unit devices (do not
connect more than four devices to each USB
Controller Card). Follow the installation instructions
for the Controller Card carefully. The PC should be
connected to the LAN for supervisor access as well
as to facilitate Windows and software updates as
needed. Additionally, it may be desirable to load PC
Anywhere on the PC for remote administration of the
application.
2. Once USB cards are installed, go to
www.windowsupdate.com. Download and install
any updated device drivers that may be available for
WIN2000 or XP and your USB Controller Cards. This
is very important, as WIN2000 does not always have
the required device drivers loaded in default for USB
2.0 devices. If your card came with a driver CD this
step may have been taken care of during installation
of the card(s).
3. Update Windows 2000 to Service Pack 4; this is
available as a free upgrade from the Windows update
web site.
4. When all USB Controller Cards are installed and the
PC updated, restart the PC.
5. Connect any USB hubs if applicable.
The brand or type of USB hub must match that of the USB
Controller Card.
6. Once USB hubs are installed, restart the PC again.
Installing SV8100/SV8300 Optional Equipment
UNIVERGE SV8100/SV8300