Makita GVP01 Instruction Manual page 11

3. Insert the sleeve 18 into the center hole of the
backing pad.
4.
Install the wool pad over the backing pad, passing
the sleeve 18 through the center hole of the wool pad.
Use the sleeve 18 as a positioning guide to align the
wool pad accurately along the backing pad.
5. Pull the sleeve 18 out of the center hole of the
backing pad.
1
2
Fig.15
► 1. Sleeve 18 2. Backing pad 3. Wool pad
Removing wool pad
1. Gently peel the wool pad off the backing pad.
2. Unscrew the backing pad while pressing in the
shaft lock.
Installing and removing wool bonnet
Optional accessory
CAUTION:
secured properly. Loose attachment will run out of
balance and cause an excessive vibration which may
cause loss of control.
NOTICE:
Never actuate the shaft lock when the
spindle is moving. The tool may be damaged.
NOTICE:
Regularly clean accessories and spin-
dle to remove dust and debris. Wipe the compo-
3
nents clean with a cloth dampened in soapy water if
necessary.
1
2
3
4
Fig.16
► 1. Wool bonnet 2. Lock nut 3. Rubber pad
4. Spindle
Installing wool bonnet
1. Press in the shaft lock to prevent spindle rotation.
2.
Place the rubber pad over the spindle, passing
the spindle thread through the center hole of the rubber
pad.
3. Install the lock nut onto the spindle, and then
tighten it clockwise using the lock nut wrench to secure
the rubber pad firmly in place.
4
3
2
1
Fig.17
► 1. Shaft lock 2. Rubber pad 3. Lock nut 4. Lock nut
wrench
4.
Lay the wool bonnet down over the rubber pad
and cover up completely.
11 ENGLISH
Make sure that the rubber pad is