Table of Contents
Advertisement
About this task
The following images indicate the location of the optional Serial module and provide a visual representation of the installation
procedure.
Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
2. Insert the optional Serial module into its slot from the inside of your computer.
3. Connect the Serial module cable to the connector on the system board.
4. Replace the two (M3X3) screws to secure the optional Serial module to the system.
Next steps
1. Install the
front
bezel.
2. Install the
side
cover.
3. Follow the procedure in
after working inside your
computer.
Removing and installing components
85
Advertisement
Table of Contents
