Seat - Yamaha BOLT 2019 Owner's Manual

Seat

To remove the seat
1. Remove panel A. (See page 7-9.)
2. Remove the bolt.
1
1. Bolt
3. Lift the front of the seat up, and
then pull the seat off.
To install the seat
1. Insert the projection on the rear of
the seat into the seat holder as
shown.
EAU55653
1. Projection
2. Seat holder
2. Place the seat in the original posi-
tion.
3. While pushing the front of the seat
down so that there is no space be-
tween the rubber dampers and the
frame, tighten the bolt to the spec-
ified torque.
4-12
Instrument and control functions
1
2
1
1. Rubber damper
Tightening torque:
Seat fitting bolt:
16 N·m (1.6 kgf·m, 12 lb·ft)
4. Install the panel.
TIP
Make sure that the seat is properly se-
cured before riding.
4