Table of Contents
Advertisement
Control Panel Installation
Flush Mounting Installation Instructions
To install a flush mount, do the following:
1.
Cut a hole in the sheet rock to the following dimensions: 8-1/4" W x 6-5/8" H.
If you use an electrical box, the box must be 1-3/8" set back from the face of the wall to accommodate the annunciator (see
Figure 4.12).
2.
Remove the knockout holes as needed for wires.
3.
Mount the annunciator back box into the mounting hole and stabilize it with mounting wires.
Position the mounting wires into the first mounting hole past the sheet rock.
4.
Secure the wires behind the screws as shown in Figure 4.13. When you place four wires in place, mount the back box into the
mounting hole in the sheet rock.
5.
After you complete wiring the annunciator to the panel, replace the electronic assembly in the back box. Place the bezel over the
back box and tighten the set screws on the bezel.
Surface Mounting
The RA-1000 can be mounted directly to a surface or can be attached to a single, double, or four-square electrical box. The Model
5860TG/TR trim ring kit is available for use when surface mounting.
1.
Drill holes in the surface to match the screw holes on the back box.
2.
Fit the trim ring over the back box.
3.
Attach the back box to the surface using screws provided.
4.
After the annunciator wiring to the panel has been completed, replace the electronic assembly in the back box. Place the bezel over
the back box and tighten the set screws on the bezel..
24
Attach second set of wires to top of back box.
Insert wires at an angle into the first holes past the sheet rock.
Figure 4.13 Flush Mounting the Back Box
supervised
power limited
Figure 4.14 Model RA-1000 Connection to the Panel
GWF-7075 Addressable Fire Alarm Control Panel Manual — P/N LS10147-002GF-E:E 06/11/2019
Secure the wires behind this screw.
Remote Annunciator
(back view)
DIP Switches
RA-1000 Remote Annunciator Installation
Advertisement
Table of Contents
