End-To-End Procedure: Low-Touch Provisioning - Cisco Firepower 1010 Getting Started Manual

Threat Defense Deployment with CDO
• Routed firewall mode only, using a routed interface.
• PPPoE is not supported. If your ISP requires PPPoE, you will have to put a router with PPPoE support
• The interface must be in the global VRF only.
• SSH is not enabled by default for data interfaces, so you will have to enable SSH later using the

End-to-End Procedure: Low-Touch Provisioning

See the following tasks to deploy the threat defense with CDO using low-touch provisioning.
Figure 35: End-to-End Procedure: Low-Touch Provisioning
between the threat defense and the WAN modem.
management center. Because the Management interface gateway will be changed to be the data interfaces,
you also cannot SSH to the Management interface from a remote network unless you add a static route
for the Management interface using the configure network static-routes command.
Cisco Commerce Obtain Licenses, on page
Workspace
(CDO admin)
End-to-End Procedure: Low-Touch Provisioning
122.
Cisco Firepower 1010 Getting Started Guide
119