Table of Contents
Advertisement
Error Code
categ Detai
Er
0x04 0x00 ReadOnlyFileAccessError
ror
0x05 0x00 CommunicationError
0x05 0x03 SpawnError
0x05 0x04 CommandTimoutError
0x05 0x05 ErrorOpeningErrorLogFile
0x05 0x06 OptionError
0x05 0x07 StartupError
0x05 0x08 OpenError
0x05 0x09 ListenError
0x05 0x0A AcceptError
0x05 0x0B NotEnoughMemoryToExecuteProcess Memory is not enough.
0x05 0x0C ArgumentListTooLargeForTheProcess Process is too long.
0x05 0x0D InvalidModeForTheProcess
0x05 0x0E ProcessTerminatedNormally
0x05 0x0F NoiseError
Table 4.2 Error codes and error messages
Note:
1. First make sure the connection of each option is complete and each component is
powered properly. Next, restart the system and execute the process again. If the same error
occurs again, reduce the baud rate before retrying. If normal operation cannot be achieved even
after making the above adjustments, contact your nearest support/technical center.
2. The file could not be properly accessed. Check if the file can be properly accessed or if the
disk is full.
Error Message
Write is specified to read-only-file.
Communication error.
Spawn error.
Command timeout error.
Fail to open log file.
Option error.
Startup error.
Open error.
Listen error.
Accept error.
Child-process ends illegally.
Child-process ends normally.
Communication noise error.
Description
25
Remedy
Change the file attribution for
write.
See note 1.
See note 1.
See note 1.
Check if the path name of log file
is correct.
Check if the selection of operation
is correct.
Check if other application is using
the COM port.
See note 1.
See note 1.
See note 1.
Close other applications first.
See note 1.
Check the operation method.
Normal end.
See note 1.
Advertisement
Table of Contents
