Output Terminals - Sanyo SRC-850 Instruction Manual

OUTPUT TERMINALS

TAPE END OUT Terminal
During recording, when the end of the tape is reached
or when the tape counter reading indicates 7 hours 57
minutes or more, the output becomes 0V (Low).
To reset the output, press the STOP or EJECT button.
During autorepeat recording, when the end of the tape
is reached, the output becomes 0V (Low) for about 2
seconds only.
Tape end or 7:57:00
Output reset
TAPE END OUT Terminal Output Setting
1
Press the MENU button until the (SET UP 5) menu is
displayed.
@@@@@@@<SET@UP@5>
öTAPE@END@OUT@@@@-3M
öWARN.@OUT@@@@@TRANSPORT
öRS485
@ADDRESS@@@@@@@@@000
@TERMINATE@@@@@@@N
@DATA@SPEED@@@@@@19200
@STATUS@INFO@@@@@Y
@ALARM@INFO@@@@@@Y
2
Press the l (or j) button, to select the desired output
mode.
–3M . . . . . . . . The output becomes 0 V (Low)
and the TAPE END indicator
flashes when the tape counter
reaches "7:57:00" and/or when
the tape reaches the end.
END . . . . . . . . The output becomes 0 V (Low)
and the TAPE END indicator
flashes when the tape reaches
the end.
4
Press the PAUSE/SEARCH button to save the
setting.
COM Terminal
Common GND (ground) terminal when connecting
other terminals to external devices.
5V (H)
(Output impedance: 5.7 k )
0V (L)
WARNING OUT Terminal
If the tape stops or other problem, the output becomes
0V (Low).
To reset the output, press the STOP or ALL RESET
button or unplug the power cord then plug it back in.
Tape movement stop
Output reset
WARNING OUT Terminal Output Setting
NOTE:
If in the (SET UP 4) menu "VIDEO LOSS" is set to "N",
the "WARN. OUT" setting will be preset to
"TRANSPORT" and cannot be changed.
1
Press the MENU button until the (SET UP 5) menu is
displayed.
2
Press the ] button, until the "WARN. OUT" setting is
flashing.
3
Press the l (or j) button, to select the desired output
mode.
TRANSPORT . The output becomes 0V (Low)
V. LOSS . . . . . The output becomes 0V (Low)
T OR V . . . . . . The output become 0V (Low)
4
Press the PAUSE/SEARCH button to save the
setting.
26
5V (H)
(Output impedance: 5.7 k )
0V (L)
when the tape stops or other
probrem with the internal
mechanism.
when there is no video signal
(Please refer to page 13, "Action
to Take when the Video Signal
Deteriorates.").
when the tape stops or other
problem with the internal
mechanism, or when there is no
video signal (Please refer to page
13, "Action to Take when the
Video Signal Deteriorates.").
English