Special Playback - Sanyo SRC-850 Instruction Manual

SPECIAL PLAYBACK

Picture Search (Forward and Reverse)
1
Press the FF (or REW) button, during normal
playback.
° The image can be seen while the tape is
advanced (or rewound) at high speed.
2
To return to normal playback, press the PLAY button.
NOTES:
During picture search, noise (horizontal bars) will
appear in the picture.
The sound is muted.
Still Image
1
Press the PAUSE/SEARCH button, during normal
playback.
A still image can be viewed.
°
2
To return to normal playback, press the PLAY button.
NOTES:
If still mode continues for 5 minutes or more, the VCR
will go into stop mode to avoid damaging the tape.
If the image is unstable (rolling vertically), adjust the
vertical lock control to correct.
Frame Advance
1
Press the FF button, during still image mode.
The still image is advanced of one image (field).
°
2
To return to normal playback, press the PLAY button.
NOTE:
If frame advance mode continues for 5 minutes or
more, the VCR will go into stop mode to avoid
damageing the tape.
English
Day/Time Search
1
Press the PAUSE/SEARCH button three times during
stop mode.
° "T/D SEARCH 01 00:00" will be displayed on
screen.
1H22M33S
T/D@SEARCH
01@@00:00
DAY@TIME
2
Press the l (or j) button to set the desired day, then
press the « button.
3
Press the l (or j) button to set the desired hour,
then press the « button.
4
Press the l (or j) button to set the desired minutes.
NOTES:
The setting can be made in 10 minutes increments
only.
For recordings made on other VCRs, the exact time
may not be found even if the minutes are entered.
For tapes recorded on older models of VCRs
produced by this company (the ones without a
minutes setting for the day/time search function),
make sure to set the minutes to "00".
5
Press the FF (or REW) button.
The desired day/time is searched and a still
°
image of the recording will appear on-screen.
6
Press the PLAY button.
Playback will start.
°
NOTES:
If during a search the end of the tape is reached, the
tape will rewind and stop. If the beginning of the tape is
reached, it will stop.
The alarm and day/time data are recorded on the tape
in a similar format. If they overlap, the alarm data will
have the priority. Therefore, when searching for a
day/time when an alarm recording was done, the
day/time search will not stop at the desired location. In
such a case, use alarm scan to find the desired
recording location.
21