AEG KO-LAVAMAT 74335 User Information page 30

Operating Instructions
Problem
The washing machine
vibrates during opera-
tion or is unstable.
Excessive foaming dur-
ing the main wash.
Water runs out from
under the washing ma-
chine.
30
Possible Cause
The transport packaging has
not been removed.
The height-adjustable screw
feet are wrongly positioned.
There is very little washing in
the drum (e.g. only one
dressing gown).
The water could not be com-
pletely pumped out before
spinning because
the drain hose is kinked or
the drain pump is blocked.
Probably too much detergent
was used.
The screw connection on the
inlet hose is leaking.
The drainage hose is leaking.
The drain pump cover is not
correctly closed.
Washing is caught in the
door.
The emergency drain hose is
not correctly sealed or is
leaking.
Solution
Remove transport packaging
according to the installation
and connection instructions.
Adjust the feet according to
installation and connection
instructions.
This does not impair the
function.
Check the drain hose and re-
move any kinks if necessary,
or clean the drain pump and,
if required, remove foreign
bodies from the pump hous-
ing.
It may be necessary to re-
duce the amount of deter-
gent used. Follow the
detergent manufacturer's
recommendations.
Tighten the inlet hose screw
connection.
Check the drainage hose and
replace it if necessary.
Close cover correctly.
Stop the programme, remove
washing from the door, start
a new programme.
Seal the emergency drain
hose correctly (see section
"Carrying out an emergency
emptying"). Call your local
AEG Service Force Centre if
the emergency drain hose
leaks.