Use The Reset Button; Erase The Settings On The Router - NETGEAR MR70 User Manual

Nighthawk Mesh WiFi 6 System with MR70 router and MS70 satellite
Note: If the router is in access point mode or bridge mode and you do not know the
IP address that is assigned to it, first try to use an IP scanner application to detect the IP
address. (IP scanner applications are available online free of charge.) If you can detect
the IP address, you don't need to reset the router to factory default settings.

Use the Reset button

CAUTION: If you use the Reset button on the router, the process erases all settings
that you configured on the router
To reset the router or satellite to factory default settings:
1. On the back of the router or satellite, locate the Reset button.
2. Using a straightened paper clip, press and hold the Reset button for at least five
seconds.
3. Release the Reset button.
When the reset is complete, the router or satellite restarts. This process takes about
two minutes.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reset.
Do not turn off the router or satellite. Wait until the router or satellite finishes
restarting.

Erase the settings on the router

CAUTION: This process erases all settings that you configured in the router.
To erase the settings on the router
1. Launch a web browser from a computer or mobile device that is connected to your
mesh network.
2. Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Administration > Backup Settings.
The Backup Settings page displays.
Manage your Router and
Satellite
112 User Manual