Assembly And Adjustment; Attaching The Auxiliary Handle - Craftsman 98020 Operator's Manual

aSSeMbly anD aDjuStMent
Warning:
ThaT The TOOl is sWiTcheD OFF aND The baTTeRy
has beeN ReMOVeD.
aSSeMbly tOOlS reQuireD (nOt SupplieD):
- phillips screwdriver
Warning:
aTTeMpTiNg TO aTTach aNy OF The FOllOWiNg
cOMpONeNTs.
attaching the guarD (figureS c anD D)
Warning:
gUaRD FiRMly iN place. The guard must always be
properly attached on the tool to protect the user.
• Remove the screw from the guard.
• keeping the guard square to the trimmer head slide it fully
into place until the retaining tab clicks into place (Ensure
that the guide rails (C1) on the guard (C2) are correctly
aligned with the guide rails (C3) on the trimmer head (C4)
(figure C). The locking tab (c5) should snapped into the
housing slot (C6).
• secure the guard with the screw (D1) (figure D).
attaching the auxiliary hanDle (figureS
e anD f)
• Push the auxiliary handle (E1) onto the tube (E2).
• slide the bolt (F1) through the holes in the auxiliary handle.
• Tighten the knob (F2) onto the bolt by turning it clockwise.
aDjuSting the pOSitiOn Of the auxiliary
hanDle (fig. f)
The auxiliary handle can be adjusted to provide optimum
balance and comfort.
• loosen the knob on the bolt by turning it counter clockwise.
• gently slide the auxiliary handle up or down the tube to the
desired height.
• Tighten the knob onto the bolt by turning it clockwise.
beFORe asseMbly, Make sURe
ReMOVe The baTTeRy beFORe
NeVeR OpeRaTe TOOl WiThOUT
C
c5
D
D1
E
E2
f
8
C2
C1
C6
C3
C4
E1
f2
f1