Assembly - Craftsman WEEDWACKER Incredi-Pull 316.73170 Operator's Manual

INSTALLING THE CUTTING HEAD SHIELD
MODEL NO. 316.73170*
WARNING:
To prevent serious personal injury, never
operate the unit without the cutting head shield in place.
1. Remove the wing nut and washer from the cutting head shield.
2. Insert the short tab (the one without a hole) on the mount
bracket into the slot on the cutting head shield (Fig. 1).
3. Rotate the cutting head shield counterclockwise to align the hole
on the cutting head shield with the hole on the mount bracket
(Fig. 1).
4. Insert the square bolt into the hole underneath the cutting head
shield (Fig. 2). Push the square bolt through the cutting head
shield and mount bracket.
5. Place the washer onto the square bolt (Fig. 2).
6. Screw the wing nut onto the square bolt until the cutting head
shield is firmly in place (Fig. 2).
INSTALLING THE CUTTING HEAD SHIELD
MODEL NO. 316.73197*
WARNING:
To prevent serious personal injury, never
operate the unit without the cutting head shield in place.
1. Place the cutting head shield under the mount bracket (Fig. 3).
Align the holes in the cutting head shield with the holes in the
mount bracket (Fig. 3).
2. Insert the screws (x2) into the aligned holes (Fig. 3). Tighten the
screws by hand until they are finger tight.
3. Tighten the screws with a #2 Phillips screwdriver until the cutting
head shield is firmly in place. Tighten the screws equally. The
gap between the mount bracket and the cutting head shield
should be the same on each side.

ASSEMBLY

Cutting Head
Shield
Cutting Head
Shield
Square Bolt
Screw (x2)
Hole (x2)
8
Slot
Mount Bracket
Fig. 1
Mount Bracket
Wing Nut
Washer
Fig. 2
Mount Bracket
Cutting Head Shield
Fig. 3