Operating Range Of Remote Control - Pioneer VSX-817-S/-K Operating Instructions Manual

04 Controls and displays
MPX*
Switches between stereo and mono
reception of FM broadcasts. If the signal is
weak then switching to mono will improve
the sound quality (page 43).
D. ACCESS*
After pressing, you can access a radio
station directly using the number buttons
(page 43).
MIDNIGHT
Switches to Midnight or Loudness
listening (page 31).
ANALOG ATT
Attenuates (lowers) the level of an analog
input signal to prevent distortion.
DIMMER
Dims or brightens the display.
SLEEP
Press to change the amount of time before
the receiver switches into standby (30 min
– 60 min – 90 min – Off). You can check
the remaining sleep time at any time by
pressing SLEEP once.
SIGNAL SEL
Use to select an input signal (page 32).
SB ch
Selects the surround back channel mode
(page 30) or virtual surround back mode
(page 31).
9 INFO
Use to bring up information screens on a
digital TV.
10 SHIFT
Press to access the 'boxed' commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (*) in this section.
11 Remote control LED
Lights when a command is sent from the
remote control.
26
En
12 SOURCE
Press to turn on/off other components
connected to the receiver (see page 48 for
more on this).
13 RECEIVER
Switches the remote to control the receiver (used
to select the green commands above the number
buttons (SETUP, etc). Also use this button to set
up surround sound (page 8, page 34).
14 TV CONTROL buttons
These buttons are dedicated to control the TV
assigned to the TV CTRL button. Thus if you
only have one TV to hook up to this system
assign it to the TV CTRL MULT CONTROL
button. If you have two TVs, assign the main TV
to the TV CTRL button (see page 48 for more
on this).

Use to turn on/off the power of the TV.
INPUT SELECT
Use to select the TV input signal.
TV CH +/–
Use to select channels.
TV VOL +/–
Use to adjust the volume on your TV.

Operating range of remote control

The remote control may not work properly if:
• There are obstacles between the remote
control and the receiver's remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
• The receiver is located near a device that is
emitting infrared rays.
• The receiver is operated simultaneously
with another infrared remote control unit.
30
30
7 m (23 ft.)