Setting The Digital Output - Pioneer DVD-V7400 Operating Instructions Manual

Setting the Digital Output

The type of digital signal corresponding to the amplifier can be selected through the player. Improper settings may
cause noise or feedback. Review the information below and refer to the Operating Manual for the amplifier.
DVD.
Dolby Digital Output
If the amplifier does not support Dolby Digital*, select the
[Dolby Digital 3 PCM] setting.
SETUP
Press
The initial Setup menu is displayed.
Select [Audio 1]
Select [Dolby Digital Out]
Press the arrow button
(right direction)
Select the preferred item
ENTER
Press
Audio1
Dolby Digital Out -
Dolby Digital:
Dolby Digital 3 PCM: Converts a Dolby Digital signal
SETUP
Press
34
En
2 Language
Video General
Dolby Digital
Dolby Digital 3 PCM
DTS Out -
96kHz PCM Out - 96kHz 3 48kHz
MPEG Out - MPEG 3 PCM
Digital Out - Off
Move SETUP Exit
For amplifiers and decoders
which support Dolby Digital
(default setting when shipped)
to a linear PCM signal if the
amplifier does not support Dolby
Digital technology
DVD.
DTS Output
When the connected amplifier supports DTS**, set to [DTS].
SETUP
Press
The initial setup menu is displayed.
Select [Audio 1]
Select [DTS Out]
Press the arrow button
(right direction)
Select the preferred output
ENTER
Press
Audio1 2 Video Language
Dolby Digital Out -
DTS Out -
96kHz PCM Out - DTS
MPEG Out - MPEG 3 PCM
Digital Out - Off
Move
OFF: For amplifiers that do not support DTS
(default setting when shipped)
DTS: For amplifiers and decoders which support
DTS output
SETUP
Press
** "DTS" and "DTS Digital " are trademarks of Digital Theater
Systems, Inc. Manufactured under license from Digital
Theater Systems, Inc.
General
Dolby Digital
Off
Exit
SETUP