Electrical Safety - Black & Decker BDCOS18 Original Instructions Manual

#

Electrical safety

Your charger is double insulated; therefore no earth
wire is required. Always check that the mains volt-
age corresponds to the voltage on the rating plate.
Never attempt to replace the charger unit with a
regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/Off switch
2. Variable speed dial
3. Super-lokTM Tool free accessory clamping lever
4. Battery
5. LED Work light
Accessories
This tool includes some or all of the following accessories.
The performance of your tool depends on the accessory used.
BLACK+DECKER accessories are engineered to high quality
standards and designed to enhance the performance of your
tool.
By using these accessories you will get the very best from
your tool.
Precision plunge cut saw blade for
wooden materials, soft plastics.
(Part number - STA26105-XJ)
Separating, plunge and flush cutting
of wood and soft plastics. Ideal for
working on doors, skirting boards,
windowsills and flooring.
Plunge cut saw blade for wood and
metal.
(Part number - STA26110-XJ)
Separating, plunge and flush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions,
nails and screws.
Plunge cut saw blade for wood and
metal.
(Part number - STA26115-XJ)
Separating, plunge and flush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions.
(Original instructions)
Charging the battery (fig. A)
The battery needs to be charged before first use and whenev-
er it fails to produce sufficient power on jobs that were easily
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
ENGLISH
Segmented saw blade.
(Part number - STA26120-XJ)
Long life blade which is ideal for
cutting wood, plastics, thin walled
ferrous and non-ferrous material.
Rigid scraper.
(Part number - STA26135-XJ)
Ideal for removal of hard and soft
material from flat surfaces such as
the removal of vinyl flooring, bonded
carpet adhesive, tile floor adhesive,
grout, paint and varnish.
Flexible scraper.
(Part number - STA26140-XJ)
Ideal for removal of elastomer
materials from hard flat surfaces in
difficult to reach areas such as silicon
sealant and other caulking materials.
Carbide grout removal blade.
(Part number - STA26125-XJ)
Carbide coated surface ideal for
clearing grout and tile adhesive from
flat surfaces and for fast stock
removal of wood, chipboard and
fibreglass.
Carbide rasp.
(Part number - STA26130-XJ)
Carbide coated surface ideal for grout
removal and for fast stock removal of
plastics, chipboard and fibreglass.
Sanding Sheets.
(Part number - STA32348-XJ)
Various grades for sanding of wood,
painted and varnished surfaces.
7