Driver Installation For Windows Vista - Linksys USB300M User Manual

Chapter 2
Power Management tab. Select Allow the
11. Click the
computer to turn off this device to save power. Click OK
to save the property settings.
Fast Ethernet Adapter Properties—Power Management tab
Congratulations! The installation of the USB Ethernet
Adapter is complete.
For more information about networking under
Windows XP or Windows 2000, refer to your Microsoft
Windows XP or Windows 2000 documentation.
USB Ethernet Adapter

Driver Installation for Windows Vista

NOTE: Do not click Cancel at any time during the
installation process. Doing so will prevent your driver
from being properly installed on your computer.
1. If you have not yet done so, start your computer.
2. Connect the Adapter to your computer. Refer to
Installing the Adapter, page 3.
3. Windows Vista will automatically detect the Adapter.
When the Found New Hardware screen appears, insert
the Installation CD into the CD-ROM drive. Then click
Locate and install driver software (recommended).
Found New Hardware
Driver Software Installation screen appears. When
4. The
the screen displays the message The software for this
device has been successfully installed, click Close. Then
remove the Installation CD from the CD-ROM drive.
Driver Software Installation—Installing Device Driver
Driver Software Installation—Device Driver Installed
Configuration
6