Run TimeSupplying Power to the PRO3200 Interface
Table 5 PRO3200 Status LED Combinations During Run Time
LED
1
2
3
4
5
6
SPD
ACT
LNK
3.5 Supplying Power to the PRO3200 Interface
The processor accepts 12Vdc for power. Locate power source as close to the unit as possible and
connect it with minimum of 18AWG wires.
Caution:
Figure 2: PRO3200 Power Terminals
TB1
PRO3200 (PRO32IC) Installation and Configuration Guide, Document 800-15494
Description
Off-Line / On-Line and Battery Status
Off-Line = 20% On, ON-Line = 80% On
Double Flash means the Battery is Low
Primary Host Communication Activity (Ethernet or Port 1)
Port 2 Communication Activity
Port 3 Communication Activity
ON = Writing to Flash Memory. Do NOT cut off power when this LED is ON.
TBD
On-Board Ethernet Speed. OFF = 10MBS. ON = 100MBS.
OFF = No On-Board Ethernet Activity. ON = On-Board Ethernet Activity
(YELLOW LED).
OFF = ON Link. ON = Good Link (GREEN LED).
Observe POLARITY on 12 VDC.
TR+
PORT 3
TR-
GND
+
+12V
-
GND
12Vdc nominal
PRO3200 Installation
Setting Up the PRO3200 Hardware
15