Cisco 9865 Quick Start Manual page 4

AFN Atlantic SATNET on Galaxy 16
AFN7500HD Decoder Settings and Channel Guide
You can also manually enter the decoder settings for your decoder by following the instructions below.
From the "Select Satellite" menu page, use the circular navigation wheel on your AFN7500HD decoder
remote control to select the "Transponder" on the third line down. Change the setting to "Manual" to
access the "Configure Transponder" menu.
The Configure Transponder page is where you enter the four settings you need for this satellite footprint.
Use the circular navigation wheel on your AFN7500HD remote control to cycle through the settings, in the
left column, for Modulation, Frequency, Polarization, and Symbol. Enter the settings as depicted below.
You can use the numeric keypad on your decoder remote control to enter the frequency and symbol
settings.
Select "Continue."
Current as of 20211104 4