Kenwood TKR-850 Instruction Manual

VHF FM REPEATER/ UHF FM REPEATER
TKR-750/ TKR-850

INSTRUCTION MANUAL

THANK YOU!
We are grateful you purchased this KENWOOD repeater.
We believe this easy-to-program repeater will be highly
effective in your communications system, and will keep
personnel operating at peak efficiency.
KENWOOD incorporates the latest in advanced technol-
ogy into all of our products. As a result, we feel strongly
that you will be pleased with the quality and features of
this product.
FEATURES
• You can easily program channel data using the KPG-66D
software on a PC.
• You can recall 1 of 16 preset channels using either a PF key
or the external control line.
• The firmware can be written to the Flash memory through
an external source.
• QT/DQT signalling can be programmed on each channel. It
simultaneously decodes up to 16 different QT/DQT tones.
• The interface port can be used with external equipment,
such as a repeater controller.
• The repeater has multi-mode capability.
Wide: 30 kHz/ Narrow: 15 kHz
Wide: 25 kHz/ Narrow: 12.5 kHz
• You can adjust the following functions from a PC:
• Squelch
• RX audio signal output (RA)
• RX detector signal output (RD)
• RX frequency
• RF output power
• Maximum deviation
• TX audio input (TA)
• Signalling deviation (TD)
• DQT balance
• QT deviation
• DQT deviation
• Test tone deviation
• CW ID deviation
• Repeat gain
• TX frequency
PRECAUTIONS
• Do not expose the unit to rain or moisture; to prevent fire or
electric shock.
• Do not open the unit under any circumstances; to avoid risk
of electric shock.
• Do not expose the unit to long periods of direct sunlight, nor
place it close to heating appliances.
• Do not place the unit in excessively dusty and/or humid
areas, nor on unstable surfaces.
• If you detect an abnormal odor or smoke coming from the
unit, disconnect the power from the unit immediately.
Contact your
KENWOOD
(TKR-750; K type only)
(TKR-750/ TKR-850)
service center or dealer.
KENWOOD CORPORATION
© B62-1327-20 (K,E)
09 08 07 06 05 04 03 02
NOTICES TO THE USER
FCC WARNING
This equipment generates or uses radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
◆
GOVERNMENT LAW PROHIBITS THE OPERATION OF
UNLICENSED RADIO TRANSMITTERS WITHIN THE
TERRITORIES UNDER GOVERNMENT CONTROL.
◆ ILLEGAL OPERATION IS PUNISHABLE BY FINE OR
IMPRISONMENT OR BOTH.
◆
REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.
UNPACKING AND CHECKING EQUIPMENT
Note: The following unpacking information is for use by your
dealer, an authorized
KENWOOD
Carefully unpack the repeater. We recommend that you
identify the items listed in the following table before
discarding the packing material. If any items are missing
or have been damaged during shipment, file a claim with
the carrier immediately.
I e t m
H a d r w a e r x i f u t e r
F o r t n g a l s s
F t l i r e
C u s h o i n
C u s h o i n
F o t o
F o t o
G o r m m t e
H a n d e l
S c e r w s
D C c o d r
C o n n e t c r o c a b e l
F u s e
W r a a r n y t c a d r K ( y t p e o
n I t s u r t c o i n m a n u l a
INSTALLATION
To install the handles onto the front panel of the repeater,
align the handles with the holes on the front panel, then
secure the handles using the supplied screws.
Please consult your dealer for installing the repeater and
antenna.
MICROPHONE
Connect an optional KMC-30 (E type only), KMC-27A,
KMC-27B, or KMC-9C KENWOOD microphone to the
MIC jack on the front panel.
service facility, or the factory.
P a t r N u m b r e
J 2 1 8 - 4 0 2 X -
B 1 0 2 - 6 3 5 X -
B 1 1 1 - 2 5 9 X -
G 1 3 1 - 8 0 1 X -
G 1 3 1 - 8 0 2 X -
J 0 2 0 - 4 7 5 X -
J 0 2 0 - 4 9 2 X -
J 5 9 0 - 3 0 2 X -
K 0 1 0 - 4 1 8 X -
N 3 5 3 - 0 0 6 4 -
E 3 0 3 - 4 2 7 X -
E 3 1 3 - 2 2 8 X -
F 0 5 1 - 5 3 7 X -
l n ) y —
B 6 2 1 - 3 2 7 X -
KENWOOD
Q a u t n y t i
4 1
4 1
4 1
4 4
4 4
5 2
4 2
5 2
5 1
5 5
5 1
5 1
5 1
1
X 1