Technical Data - AEG SCT71900S0 User Manual

Problem
Temperature cannot be
set .
The temperature in the
appliance is too low/high.
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.
Replacing the lamp
The appliance is equipped with a longlife LED interior light.
Only service is allowed to replace the lighting device. Contact your Service Center
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Possible cause
FROSTMATIC or COOLMATIC
functions switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Height
Width
Depth
Technical data
Solution
Switch off FROSTMATIC or COOL-
MATIC manually, or wait to set
the temperature until the func-
tion has reset automatically. Re-
fer to "FROSTMATIC or COOLMAT-
IC function"..
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
1850 mm
560 mm
560 mm
21 h
230-240 V
50 Hz
17