Hammerhead REMORA PORTABLE POOL VAC Quick Start Manual

HAMMER-HEAD® REMORA™ PORTABLE POOL VAC
STEP 2 - CHARGING THE HAMMER-HEAD®
Your REMORA™ pool cleaner is equipped with a 12 volt Power-Sonic® LiFeP04
Lithium ION Bluetooth battery. The battery is thermally protected and completely
sealed. No maintenance other than charging is required.
You can charge your battery at any time, but do not allow the battery to discharge to 0% completely
before recharging, as the app and the charger may not be able to detect the battery at all if it is
completely dead. Plug the charger into a wall outlet, then connect the male end of the charger to the
REMORA™ battery case as shown. Using the MODE button, set the charger to LITHIUM. NOTE:
You must set the charger to the LITHIUM setting each time you charge your battery. The charger will
automatically recharge the battery to 100% capacity and then maintain it until the next use.
NOTE: Due to the safety features in both your battery's BMS, the Smart Switch, and the NOCO G2
charger, an excess voltage error may occur during charging.The battery and charging system is safe,
and the error does not indicate anything is damaged. The charger will go back to it's regular charging
cycle after some time. If it does not correct itself or you would like to restart the cycle manually, simply
unplug the charger from the battery case, wait 10 seconds and then plug it back in.
QUICK-START GUIDE
Step 1 - USING THE APP
Download the free Power-Sonic® app to your smart device.
It will connect to the battery in your REMORA™ battery pack
and monitor the state of charge (SOC). On the second pane
(page) of the app, you'll be able to see the current condition of
your battery, even as you use it. See the Power-Sonic® guide
for instructions on using the app. Click here to download the
guide.
REMORA™ BATTERY