Necessary Repairing Tools - Makita DCS230T Technical Information

[II] Disassembly/Assembly/Adjustment

1. Necessary Repairing Tools

Tool No.
1R003 Retaining Ring Pliers ST-2N
1R028 Bearing Setting Tool 20-12.2
1R034 Bearing Setting Plate 12.2
1R048 Drill Chuck Remover 11
1R091 Copper Round Bar 20-100
1R127 Air Tightness Tester
1R170 T-type Hex Wrench 3-127
1R171 T-type Hex Wrench 4-130
1R229 1/4" Hex Shank Bit for M5
1R269 Bearing Extractor
13mm Hex Socket Bit
Impact Driver (6990D, 6916D or the like)
Iron Hammer
0.3mm Thickness Gauge
0.7mm Spark Plug Gauge
2. Lubrication/Sealing
After you have disassembled the following parts, do lubrication or sealing as instructed below.
Needle bearing on clutch drum: Apply Makita grease N No. 2.
Spiral spring of recoil starter: Apply Makita grease N No. 2.
Engine: Apply Three bond 1215 to the contact surface between Crankcase and Cylinder.
Description Use for
Disassembling/assembling kickback brake
(inertia chain brake) system
Press-fitting Bearing to Crankshaft
Removing Flywheel
Testing Carburetor
Removing/installing M4 Hex socket head bolt
Removing/installing M5 Hex socket head bolt
Removing Engine
Removing Bearing from Crankshaft
Removing/installing Clutch and Flywheel
Removing Flywheel
Fixing and adjusting Ignition coil complete
Adjusting spark gap of Spark plug
2 / 20