Led Indications - Motorola APX 3000 User Manual

• The radio Voice Announcement announces the programmed Wrong Battery.
• The battery icon blinks continuously.
• A repetitive tone sounds.
• Red LED blinks continuously.
NOTE:
The radio does not display any indication when the radio is connected to the charger, the radio
and battery match, or when the radio certification type is configured as None in Customer
Programming Software (CPS).
This feature is enabled through CPS configuration. Check with your dealer or system administrator for
more information.
4.2

LED Indications

The LED indications represent the operational status of your radio.
For covert operation, the LED can be preprogrammed to turn off in a specific zone or channel. During
operation in these zones or channels, Voice Announcement is used to hear and confirm the operation
status.
Table 1: LED Indications
Indication
Solid red
Slow blinking red
Rapid blinking red
Solid yellow
Blinking yellow
Solid green
Solid blue
Solid blue for 2 seconds
Blinking blue 3 times
Blinking blue
Blinking blue at heartbeat pace
Rapid blinking blue for 2 seconds
Solid red and solid green
Solid green blinking blue
Blinking red and blinking blue
Status
Radio is transmitting.
Radio is transmitting at low battery condition.
Radio has failed the self-test upon powering up
or encountered a fatal error.
Channel is busy in conventional mode.
Radio is receiving a secured transmission.
Radio is powering up or radio is locked.
Radio is powering up with Option Board error.
Bluetooth device is connected or disconnected.
Bluetooth is powering on or off.
Radio is clearing Bluetooth pairing information
and waiting to be paired.
Radio is connected with a device in the Blue-
tooth link.
Radio fails to connect or disconnect from a de-
vice.
Radio is upgrading the firmware.
The Customer Programming Software is read-
ing or upgrading the radio.
Radio is powering up with an update in pro-
gress.
68012007043-EM
Chapter 4 : Status Indicators
27