Table of Contents
Advertisement
Cutting Height Adjustment
The cutting height can be adjusted by three methods:
•
Moving spacers between the upper side and
the lower side of the caster swivel according to
"Cutting Height Table". For instruction, see below.
•
Moving spacers between the upper side and the
lower side of the blades according to "Cutting
Height Table". For removing and installing blades,
refer to "Blade replacement".
•
Rear axle height adjustment according to the
following instruction.
1.
Stop engine and place motion control levers
in the neutral lock position. Remove spark
plug wires.
2.
Remove lower belt shield from underside
of rear deck for better access to axle
adjustment bolts.
3.
loosen axle pivot bolts and axle adjustment
bolts. See illustration.
4.
Place a jack under center of rear deck.
Raise the jack slightly so axle adjustment
bolts may be removed.
5.
With the jack, raise or lower the rear deck
to the desired position using the chart to
ensure proper height.
6.
Reinstall the axle adjustment bolts and
tighten. A tapered punch may be used to
help align the holes.
Using the "Cutting Height Table", find the
7.
correct number of spacers to be placed
under the caster swivel.
8.
Remove the lynch pin and washer from the
top of the caster and reposition spacers to
the desired cutting height from the table.
See illustration.
IMPORTANT INFORMATION
It may be necessary to readjust drive
and brake linkages.
IMPORTANT INFORMATION
To achieve the best quality cut, the
blades should be level with the ground
or slightly tipped forward.
30 - Husqvarna
OPERATION
3
1. Axle pivot bolt
2. Securing bolts (loosen each side)
3. Axle adjustment bolts
Rear axle height adjustment
3
1. Machinery bushing
2. Caster swivel
3. Spacers, ½"
Rear axle height adjustment
1
2
1
2
8011-482
8011-405
Advertisement
Table of Contents
