Table of Contents
Advertisement
The PDJ-A640 supports the SNMP (Simple Network Management Protocol). The required settings of the
SNMP Agent of the SNMP function can be established using Telnet. Establish the following settings to
enable the network monitoring using SNMP.
For structure of the MIB that is installed in the PDJ-A640, the information that can be obtained, and
details of the Trap information that is notified from the PDJ-A640 to the SNMP Manager, refer to the
Maintenance Manual of the PDJ-A640.
6-1. SNMP Installation Specifications and System Configuration
6-1-1. SNMP Installation Specifications
Specifications of the SNMP Agent that is installed in the PDJ-A640 are shown below.
SNMP version
MIB definition
Supported PDU
Standard MIB to be installed
Extension MIB to be installed
6-1-2. Default Community Settings When Shipped from the Factory
Default community settings when shipped from the factory are shown below.
Community Name
Read-Only Community
Read-Write Community
Trap Community
PDJ-A640 IM
Section 6
SNMP
SNMPv1
SMIv2
GetRequest, GetNextRequest,
SetRequest, GetResponse, Trap
MIB-2
SONY-PRO-MIB
PROV1-XDCAMCART-MIB
Default settings
Function
public
Sets name of the read-only community.
Used to read the MIB that is installed in XDCART.
Private
Sets name of the read-write community.
Used to read and write the MIB that is installed in
XDCART. Settings are required when writing the
system variables (sysContact, sysName, sysLocation)
of the XDCART MIB-2 from the SNMP Manager.
public
Sets name of the community of the Trap information
that is issued from XDCART.
6-1 (E)
Advertisement
Table of Contents
