Table of Contents
Advertisement
. Barcode check by a test mode 40
Check the barcode by a test mode 40 with the control panel.
(Refer to the " Test Mode " of the maintenance manual for the operating procedure.)
CONTROL
CLEAR
INITIAL
10's digit
1's digit
EXECUTION
TEST
DOOR
EMERGENCY
OPEN
Setting
Set the DIP switch (S2) on the Main CPU/Robot IF board.
n
The inside of the cart is dark, so use a light to illuminate the area for work.
(1) Turn on the DOOR OPEN key on the control panel located on the upper right of the door to open the
door.
(2) Turn off the power switches of the Robot and Main at the lower right of the front panel.
(3) Unplug the power cable from the AC inlet on the rear side of the main unit.
n
Removing the power supply cover when the power is turned on may short-circuit the connection to
the power supply.
(4) If the elevator block is suspended in the middle, move it down the bottom.
(5) Remove the three screws, and remove the two claws on the power supply cover from the two grooves
in the main frame, and then remove the power supply cover in the direction of the arrows.
PDJ-A640 IM
TEST-40
BARCODE CHECK 1L
RECOVER
/START
/CANCEL
STOP
Barcode type
3-15 (E)
Advertisement
Table of Contents
