Water Supply Is Cut Off Warning; Water Overflow Warning; Adjusting The Amount Of Rinse Aid - Beko BDFN Series Manual

in salt on the screen starts to light up.
Adjusting the water hardness level
is described in the Water softening
system section.
Rinse aid level warning indicator
( )
Check the low rinse aid level warning
indicator on the display to determine if
the rinse aid available in your machine
is adequate. Rinse aid should be added
to the rinse aid compartment when the
low rinse aid level warning indicator on
the display begins to illuminate.

Adjusting the amount of rinse aid

1. Simultaneously press the On/Off
button and the Start button.
program P2 for 3 seconds. Then
enter the settings menu after
turning on your machine using
the On/Off key. Depending on
your device model, you can enter
the settings menu by pressing the
P3 key for 3 seconds.
2. Switch to the "P" position on the screen
by pressing the P2 key.
3. Set an appropriate level by
selecting one of the positions
"P:0", "P:1", "P:2", "P:3" or "P:4"
with the P3 program key.
4. To save, exit the settings menu by
pressing the On/Off button on
your machine for 3 seconds. Your
settings will be saved
automatically.
Does not apply rinse aid in position
P:0 during the wash programme.
Apply 1 dose of rinse aid in position
P:1.
Apply 2 doses of rinse aid in position
P:2.
Apply 3 doses of rinse aid in position
P:3.
Apply 4 doses of rinse aid in position
P:4.

Water supply is cut off warning

If the mains water supply is interrupted or
the water inlet tab of the machine is not
open, water will not flow into the machine
and the E:02 icon will flash on the program
indicator. As long as the error persists, the
washing program is stopped and it is
checked whether or not water flows
through the machine at certain intervals.
When the water is flowing, the E:02 icon
turns off after a while and the wash cycle
resumes.

Water overflow warning

If there is excessive water flow into the
machine or a leak in any part, the
machine will detect an overflow and the
E:01 icon will flash on the program
indicator. As long as the overflow
continues, the safety algorithm works
and tries to evacuate the water in the
machine. Once the overflow stops and
the safety procedure is completed, the
E:01 icon will turn off. If the E:01 icon
does not go out, the error is permanent
and you must call for service.
37/EN