Table of Contents
Advertisement
19. using the forklift, lift the entire assembly
approximately 2" off the ground to gain clear-
ance for filter installation.
20. Mount the two filters to the braces with
brace gaskets between them, as shown in
figure 24, using (8)
and (8)
⁄
" fender washers.
5
16
rubber
gaskets
here
figure 24. Canister filters mounted to the long
support braces.
21. Attach one roll of 3 x 15 x 700mm foam tape
to both ends of each noise muffler, then
connect them between the outlet ports and
the canisters with the 8" flexible hoses and
clamps, as shown in figure 25.
figure 25. noise mufflers connected between
the outlet ports and the canisters.
Model g0442/g0601 (Mfg since 3/12)
⁄
"-18 x
⁄
" hex bolts
5
3
16
4
x 8
noise
Muffler
22. using the forklift, raise the assembly up and
attach the lower stand legs to the upper stand
legs, as shown in figure 26, using (24)
x
⁄
" hex bolts, (48)
3
4
⁄
"-16 lock nuts.
3
8
figure 26. Attaching lower legs to the initial
stand assembly.
23. Attach the casters to the bottom of the lower
collection drum, as shown in figure 27, using
the (4)
⁄
"-16 hex nuts, (8)
3
8
and (4)
⁄
" lock washers included in the box
3
8
with the casters.
x 4
figure 27. Casters attached to the lower
collection drum.
⁄
"-16
3
8
⁄
" flat washers, and (24)
3
8
x 24
⁄
" flat washers,
3
8
-25-
Advertisement
Table of Contents
