Table of Contents
Advertisement
6.
Access (2) jack screws through holes in
cutterhead (see Figure 39). Rotate jack
screws to raise or lower knife. When knife
is set correctly, it will barely touch bottom
of straightedge in each of the straightedge
positions. Snug clamp bolts just tight enough
to hold knife in place, and repeat Steps 5–6
with remaining knife.
Figure 39. Knife adjustment jack screws.
7.
Verify knives are set even with outfeed table
by performing Step 3 of Checking Knife
Height on Page 38.
8.
When knife heights are set correctly, fully
tighten each of the knives' clamp screws
according to the tightening sequence shown
in Figure 40.
3
1
Figure 40. Knife clamp screw tightening
sequence.
9.
Install cutterhead guard removed in Step 2
on Page 38 and verify proper operation.
10. Disengage cutterhead lock before beginning
operations.
Model G0945/G0946/G0947 (Mfd. Since 06/21)
2
4
Checking/Adjusting
Table Parallelism
If the infeed and outfeed tables are not parallel
with the cutterhead and each other, then poor cut-
ting results and kickback can occur.
Table parallelism is factory-set, and should not
normally need to be adjusted when the machine
is new. However, after prolonged use, or if
machine has been jarred during lifting or trans-
portation, it may become necessary to adjust the
table parallelism.
The knives/indexable inserts are very sharp
and can easily cut your hands. ALWAYS
use caution when making adjustments near
these parts to reduce risk of personal injury.
Although some figures might not exactly
represent your machine, this process is the
same on the G0945, G0946, and G0947.
Items Needed
Straightedge 24" ................................................ 1
T-Handle Torx Driver T-25 (G0946/G0947) ....... 1
Hex Wrench 4mm .............................................. 1
Flat Head Screwdriver
Checking Outfeed Table
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen (2) button head cap screws secur-
ing cutterhead guard to jointer base, then
remove cutterhead guard.
3.
Remove fence or move it all the way back.
Qty
⁄
" ................................. 1
3
8
-39-
Advertisement
Table of Contents
