Checking What's At The End Of A Disc; Recording Blank Sections - Pioneer Elite PRB-19RW Operating Instructions Manual

Checking What's at the End of a Disc

You don't have to record a whole disc at once. Until you finalize the disc, further recording is possible from the end of the
last track you recorded (assuming there are fewer than 99 tracks already on the disc). Here's how to check what's on the
last recorded section of the disc before recording new material:
2 1
Hi-bit Legato Link Conversion

Recording Blank Sections

This feature is useful when you want to put some space at the end of a recording session so that the next recording doesn't
start after the last too closely, but use it wherever you need some blank space recorded on the disc. There are a couple of
restrictions on using record mute: you can only record one mute per track; and you can't begin a recording with a muted
section— you can use it only after the recording has started, or at the end of a recording.
2 1
Hi-bit Legato Link Conversion
1
Press ¶ RECORD.
The recorder goes into record-pause mode.
1
2
2 Press and hold 1 (fast-reverse).
You'll hear the last recorded track in reverse. Release the button and the
track plays normally to the end.
While the track is playing you can use the 1 and ¡ (fast-reverse/
❖
forward) buttons
If you press ¶
❖
jumps to the end of the track and goes into record-pause mode again.
When the track has played out, the recorder automatically enters record-
pause mode again.
3
Once the player is back in record-pause mode you
can go ahead and record normally.
If you decide you don't want to record, just press 7 (stop).
1
While recording or during record-pause mode,
1
press • REC MUTE.
A blank space of about four seconds is recorded, then the recorder goes
into record-pause mode.
2
If you press and hold •
❖
as you hold down the button.
2
Press 7 (stop) to finish the recording session.
To restart recording, press either 3 (play) or 8 (pause).
❖
Additional Recording Features
again while the track's playing, the recorder
RECORD
, you can record a blank for as long
REC MUTE
29
<PRB1286>