D-Link DIR-822 User Manual page 74

Section 4 - Configuration
Indicates to which protocol(s) the filter applies.
Protocol:
Indicates the IP address range and port(s) to which the filter applies.
[Source IP
address]
To enable schedule on a filter, click the Set schedule button ( ). In the
opened window, you can create a new schedule (see the Schedule
section Simplified mode on page 119page 118)
General Settings
Toggle this switch to enable the rule.
Enable rule:
Specify a name for the rule. This name is for reference only and does
Name:
not affect functionality.
Choose the action to be taken when the rule is triggered. Choose
Action:
Allow or Deny.
Choose which protocol to which the rule will apply. Choose from TCP/
Protocol:
UDP, TCP, UDP, ICMP, or <All>
Choose if the rule should apply to IPv4 or IPv6.
IP version:
Choose the direction to be taken when the rule is triggered. Choose
Direction:
from LAN to WAN, WAN to LAN or LAN to Router.
Destination IP Address
Choose Range or single IP address to enter a specific IP address or
Set as:
ranges for the destination filter. Choose Subnet to specify a subnet
only.
D-Link DIR-822 User Manual
IP Filter Create/Edit
70