Setup; Connecting To Peripheral Devices - Yamaha RM-CR Reference Manual

SETUP

In order to use this unit, setup is required. First, connect this unit to peripheral devices, and then perform setup using the Web GUI.

Connecting to peripheral devices

This unit is one of the components of the complete and customizable ADECIA communications solution. Refer to the diagram below
(showing the ADECIA wireless solution as an example) to connect this unit to peripheral devices with LAN cables.
RM-WAP-8
SWR2311P-10G
RM-CR
IMPORTANT: There is a DIP switch for specifying settings on the back of each VXL1-16P. Before plugging in LAN cables, set the
DIP switches as shown below. The DIP switch settings on the two units must not be the same.
RM-WCH-8,
RM-WOM/RM-WDR/
RM-WGL/RM-WGS
1st unit
RM-CR Reference Manual
2
2nd unit
VXL1-16P