Specifications; Rotary Hammer Safety Warnings - Makita HR4001C Instruction Manual

ENGLISH
(Original instructions)
1 Switch trigger
2 Switch lever
3 Adjusting dial
4 Change lever
5 Pointer
6 Lock button
7 Power-ON indicator lamp
(green)
8 Service indicator lamp (red)
9 Side handle

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
6
Explanation of general view
10 Clamp nut
11 Side grip
12 Bit shank
13 Bit grease
14 Bit
15 Chuck cover
16 Depth gauge
17 Clamp screw
18 Blow-out bulb
19 Screws
Model
Carbide-tipped bit
Core bit
–1
)
HR4001C
6.3 kg

ROTARY HAMMER SAFETY WARNINGS

1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
ENE044-1
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
ENF002-2
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly recom-
mended that you wear a dust mask and thickly
GEA010-1
padded gloves.
5. Be sure the bit is secured in place before opera-
tion.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm
up, hammering operation is difficult.
8. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
20 Connector
21 Black
22 White
23 Screw
24 Crank cap cover
25 Control plate
26 Screwdriver
27 Crank cap
28 Hammer grease
HR4010C HR4011C
40 mm
105 mm
235 – 480
1,350 – 2,750
468 mm
6.7 kg
/II
6.7 kg
GEB007-7