Unpacking Storage Systems - Hitachi DKC910I Installation Section

Hitachi Proprietary
Rev.3
INST(IN)04-01-10

4. Unpacking Storage Systems

• The unpacking should be done by two or more workers to prevent turning over of the Storage
System or being caught under the Storage System.
• Work carefully because the mass of the single DKC is about 75 kg, SBX is about 24 kg, UBX is
about 27 kg, FBX is about 38 kg, NBX is about 21 kg, and HSNBX is about 15 kg.
1. Unpacking
NOTE : • Unpack it indoors.
(1) Remove the outer package and packing materials.
(2) Take the Storage System out of the polyethylene bag.
(3) Remove tapes, etc. applied to the Storage System.
(4) Remove desiccating agent from the lower of the Storage System.
(5) Check that the Storage System has no distortion or damage owing to the transport.
Figure 4-1 Packed Storage System
Accessory box
Buffer pad (Upper)
Desiccating agent
(DESICCANT)
Storage System
Especially, do not unpack it in such places with the outdoor dust, the direct sunlight,
and the infiltration of rainwater.
• Work on the unpacking in the place where a rapid difference of temperature does
not occur. It may have dew condensation when it is unpacked in the place where a
difference of temperature is extreme.
Figure 4-1 shows the packed Storage System status.
Front Bezel
Polyethylene bag
Buffer pad (Upper)
Polyethylene bag
Pad
Buffer pad (Lower)
Corrugated cardboard box
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
[INST(IN)04-01-10]