Installation Of Rku Rack And Side Cover - Hitachi DKC910I Installation Section

Hitachi Proprietary
Rev.1
INST(IN)02-03-10

2.3 Installation of RKU Rack and Side Cover

• Make sure that the equipment is moved by two or more persons.
• Be sure to move the equipment by pushing it from the front face in the direction of movement.
It is acceptable for two persons to move the equipment carefully from the front face and rear
face only when installing it. Do not push the equipment from the side face in principle.
• The front caster of the rack frame is not a rotary type but a fixed type not to incline the
equipment at over the tipping angle. Therefore, the equipment should not be rotated quickly.
Moving the equipment normally
Move the rack frame only from the front face in principle.
Push the rack frame slowly with thumbs and the bases of them on both ends of the front face.
When changing moving direction, do so little by little in cooperation with an assistant instead of changing
moving direction quickly.
An assistant should not pull only the rear door strongly because doing so may cause the deformation of
the rear door.
Figure 2-5 Normal Movement Operation
Front View of
Rack Frame
40mm
Rear Door
Rear View of
Rack Frame
DKC910I
Copyright © 2019, 2021, Hitachi, Ltd.
40mm
Door Lock
40mm
[INST(IN)02-03-10]