Table of Contents
Advertisement
6.
Reassemble the housing unit by closing the upper body and latching the lid tight.
7.
If applicable, reinstall the sunshield by sliding it across the top of the housing.
Mounting the Wall Bracket
To mount the wall bracket:
1.
Use fasteners of an appropriate size and type to attach the bracket to the wall
surface. Position the housing so that it allows for viewing the selected area.
2.
Locate the two nuts that freely slide along the channel. Position the nuts
approximately 2 inches from each other.
3.
Place the housing onto the mount, aligning the holes. Insert the two 1/4"-20 UNC
screws (supplied) through the mount and into the nuts and tighten to secure the
assembly.
4.
Adjust the moveable arm of the wall bracket to attain the desired position.
5.
Tighten the bolt located at the pivot point of the moveable arm and tighten the set
screw.
2. Position the
two nuts 2"
apart.
3. Secure the housing with
2 x 1/4 x 20 UNC screws.
Rev A
6. Latch the lid.
4. Adjust the arm,
then tighten the
set screws.
12
1. Attach the
bracket to the
wall using 4
sheet metal
screws.
Document 800-04354
04/09
Advertisement
Table of Contents
