Operating Instructions; About The Controls On The Air Conditioner; Air Conditioner Controls; Remote Control - GE AEM12AN Owner's Manual And Installation Instructions

About the controls on the air conditioner

Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
The display always shows
the room temperature
except when setting the
Set temperature or the
Delay timer.

Air Conditioner Controls

Controls
Power Pad
Turns air conditioner on and off. When turned
on, the display will show the room temperature.
Display
Shows the room temperature or time remaining
on the Delay timer. Shows the Set temperature
while setting the temperature in Cool or Energy
Saver modes. The Set light will turn on while
setting.
NOTE: The display will change to show the room
temperature after settings have been made.
To recall the Set temperature, press the Temp
Increase or Decrease pads.
Temp Increase /DecreasePads
Use to set temperature when in Cool or Energy
Saver mode. The Set light will turn on while
setting.
Delay Timer Increase (+) /Decrease(–)
Pads
Each touch of the Increase / Decrease pads
on the unit or the Increase
on the remote control will set the delay time
when using the Delay 1–24hr timer (
light will turn on while setting.
Fan Speed Pads
Use to set the fan speed to Low, Med, High
or Auto on the unit. NOTE: On the remote
control, use the fan speed Increase
Decrease
Med or High. Use the Auto pad to turn Auto
fan on.
Power Outage Recovery Feature
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
4
used after the power is restored. If the Delay 1–24hr
Light indicates the unit
is in the temperature or
delay time Set mode.
Light indicates the delay timer is set.
+
/ Decrease
+
+
–
pads to set the fan speeds to Low,

Remote Control

Mode Pad
Use to set the air conditioner to Cool, Energy
Saver or Fan Only mode.
Delay Pads
Delay ON—When the air conditioner is off, it can
be set to automatically come on in 1 to 24 hours
at its previous mode and fan settings.
Delay OFF—When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or the
+
pad on the remote control. Each touch of the
Increase / Decrease pads on the unit or the
Increase
the remote control will set the timer in
1-hour intervals. The Set light will turn on while
setting.
To review the remaining time on the Delay
1–24hr timer, press the Delay 1–24hr pad on the
–
pads
unit or the
Increase / Decrease pads on the unit or the
). The Set
Increase
control to set a new time if desired.
To cancel the timer, press the Delay
1–24hr pad until the light on the Delay 1–24hr
pad goes off.
/
feature was set, it will resume countdown. You may
need to set a new time if desired.
Fan Fan
+ –
/ Decrease pads on
+
pad on the remote control. Use the
+ –
/ Decrease pads on the remote